Connect the controller
- Plug the tablet's USB-C into the controller's USB socket (USB-C to USB-B cable, or an OTG adapter).
- Tap Connect and pick the Arduino Mega. Android asks once whether Chrome may use the device.
- Connecting restarts the controller (as on a PC): the stage drivers then need Init drivers.
Driversasleep
Limit switches?
Brushless motor open-loop spin
Open loop: no current control and no position feedback, only a sync check on the Hall sensors.
Stay at the machine while it runs.
Motor (Hall)
0rpm
Output
0.0rpm
State
off
Set speed (motor rpm)600
Details
Ramps at about 200 rpm/s up and 480 rpm/s down. The controller stops the motor by itself on a gate-driver fault, lost 24 V, a motor probe above 110 °C, or when the rotor falls out of sync. Output rpm = motor rpm ÷ gear ratio (from the profile settings).
Speed profile 100 slots per output revolution, % of max speed
Drag across the bars to draw. Slot –
Settings
Max output speedrpm (≤ 50)
Gear ratio:motor : output revs
Direction
Accelerationoutput rpm/s
Autostart
Controller
"Send" changes the running settings; "Save" keeps them over a power cycle (EEPROM).
Running a profile needs closed-loop motor control (firmware milestone 4). Until then the controller refuses
prof run; use the Motor tab for open-loop runs.
Encoder bits live
Value
–
Changes
0
Rate
0/s
Lit track = 0, dark = 1. Bits come in the controller's pin order; through the box's extension that is 1991 lines 2, 1, 4, 3, 6, 5, 7 (shown under each bit).
Capture fast sampling for decoding
Samples
everyµs
Turn the disk slowly while capturing. 1024 × 1 ms ≈ 1 s.